ObsidianWire Custom Split Coil for Les Paul 60's pre-wired kit

Description

ObsidianWire Custom Split Coil for Les Paul 60's pre-wired kit
The ObsidianWire Custom Split Coil for Les Paul 60's pre-wired kit - 500k CTS pots
ObsidianWire Custom SC (Split Coil) Pro-Wired Electronics for Les Paul® are a pop in replacement for your old Gibson® Les Paul® wiring harness. It adds valuable flexibility by allowing you to split your humbuckers (requires 4 conductor pickups) into single coils for classic, low output spank.
Best of all, ObsidianWire Pro-Wired Electronics are super easy to install, and allow for unlimited solder-less pickup changes with Plug, Play and Enjoy connectors.
The ObsidianWire SC set allows you to individually split your humbucker pickups into single coils, allowing for Strat® or Tele® like tones without changing pickups. Each pickup has its own switch, so you can split each one on its own, or both at the same time.
Best of all, the switch is incorporated into the volume controls, so there is no need to drill additional holes. Just pull up the corresponding volume control and the magic is done. Press it down, and you are back to the full humbucker power.
Both Switches Down (Traditional LP)
Position 1:
Bridge Humbucker
Position 2:
Bridge Humbucker + Neck Humbucker
Position3:
Neck Humbucker
Both Switches Up
Position 1:
Bridge Single Coil
Position 2:
Bridge Single Coil + Neck Single Coil
Position3:
Neck Single Coil
Neck Volume Switch Up - Bridge Volume Switch Down
Position 1:
Bridge Humbucker
Position 2:
Bridge Humbucker + Neck Single Coil
Position3:
Neck Single Coil
Neck Volume Switch Down + Bridge Volume Switch Up
Position 1:
Bridge Single Coil
Position 2:
Bridge Single Coil + Neck Humbucker
Position3:
Neck Humbucker
ObsidianWire 60s - Cut Through at Any Volume
The ObsidianWire 60s wiring retains treble when you roll back the volume control allowing you to retain your overall tone and cut through at lower volumes. The controls are more intuitive with the 60s set, with the tone control changing tone and the volume control changing the volume.
ObsidianWire Pro-Wired Electronics are built using the world’s best craftsmanship and components:
2 x Premium Selected CTS Split Shaft Pots 500k (+/-6%) (Matched to +/-2%) (Long Shaft with extra nuts can be used with long shaft or short shaft guitars)
2 x Premium Selected CTS Split Shaft Push / Pull Pots 500k (+/-6%) (Matched to +/-2%)
1 x Genuine Switchcraft Short Toggle Switch (Pro-Wired for use in Gibson® Les Pauls® + Epiphone® Les Pauls® with a little modification)
2 x Obsidian Select Capacitors (150 Series Polyester Film 0.022uf) (Hand Tested to +/-10%)
1 x Genuine Switchcraft J11 Mono Output jack
1 x Pre Printed & Easy to Follow Wiring Diagram
1 x Endless Customer Support
Compatibility:
Requires 4 conductor pickups
- Will work without split coil capability with regular two conductor pickups.
ObsidianWire Pro-Wired Electronics for Les Paul, are designed to be a direct fit for American Gibson® Les Pauls®.
They can also be used and are a great upgrade for Epiphone® Les Pauls. Please note that for Epiphones you will need to widen the holes in the body for the higher grade, US spec electronics and get new 24 spline knobs to fit. Attempting to use your old metric knobs will damage your new Pro-Wired Electronics.